Flow, Filling Ability and Apical Extrusion of New Calcium Silicate-Based Sealers: A Micro-Computed Tomographic Study

Download Citation in txt Download Citation in bib Download Citation in ris

Author Info

Fernanda F. E. Torres Jáder C. Pinto Juliane M. Guerreiro-Tanomaru Mariana C. Pereira Mario Tanomaru Filho Pedro H. F. de Souza

Corresponding Author

Mario Tanomaru Filho
Department of Restorative Dentistry, São Paulo State University (UNESP), School of Dentistry, Araraquara, São Paulo, Brazil

A B S T R A C T

Aim: To evaluate flow, filling ability, and apical extrusion of three calcium silicate-based sealers, Neo MTA Plus (Avalon, USA), Bio-C Sealer (Angelus, Brazil) and Sealer Plus BC (MK Life, Brazil), in comparation with the gold standard based on epoxy resin, AH Plus (Dentsply, Germany). Methodology: The flow was evaluated based on ISO 6876/2012 standard (mm) and in area (mm2 ). For assessment of filling ability and apical extrusion of the sealers, curved artificial canals were prepared up to size 25.06, and filled with the sealers by the single cone technique. The samples were scanned in microcomputed tomography (SkyScan 1272. Bruker, Belgium) after preparation and after filling of the root canals. The percentage of voids throughout the entire extension of the root canals and in the apical third, besides the volume of apical extrusion of each sealer were calculated. Data were statistically analyzed using ANOVA/Tukey tests (α = 0.05). Results: Bio-C Sealer showed the highest flow and NeoMTA Plus had the lowest value (p < 0.05). Bio-C Sealer had lower percentage of total voids than NeoMTA Plus (p < 0.05). AH Plus had greater percentage of voids in the apical third than Bio-C Sealer and Sealer Plus BC (p < 0.05). Bio-C Sealer showed higher volume of extrusion (p < 0.05) than AH Plus and NeoMTA Plus. Conclusion: Bio-C Sealer and Sealer Plus BC had greater flow and proper filling ability in the apical third. However, these sealers presented high volume of apical extrusion. NeoMTA Plus provided less sealer extrusion, low flow, and more presence of voids.

Article Info

Article Type

Research Article

Publication history

Received: Thu 21, May 2020
Accepted: Sat 06, Jun 2020
Published: Mon 15, Jun 2020

Copyright

© 2023 Mario Tanomaru Filho. This is an open-access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited. Hosting by Science Repository.
DOI: 10.31487/j.DOBCR.2020.03.04